The best time to plan is
before the walls go up.
Retrofitting a finished home costs 3x more than planning it right during construction. We work with your builder to make sure every cable, every access point, and every smart home component is exactly where it needs to be, before drywall.
Book a ConsultationMost homes are built without thinking about technology.
Your builder builds the house. Your electrician runs the power. But nobody thinks about where the wireless access points should be mounted, where the ethernet runs need to terminate, how the smart home systems will be powered and connected, or where the equipment rack should live. That gap gets expensive after the fact. We close it before it opens. That includes audio. Running speaker wire through a finished wall costs more and looks worse than planning it at the framing stage.
Network Infrastructure Layout
Access point locations, ethernet run paths, equipment room placement. Planned before a single cable is pulled.
Smart Home Pre-Wire
Every device, every system, every automation, wired correctly from the start. Audio runs. Network runs. Smart home runs. Nothing requires retrofitting later.
Builder Coordination
We work directly with your builder and electrician. We give them exactly what they need to do it right the first time.
Future-Proof Design
Technology changes. We plan infrastructure that can adapt: conduit paths, panel capacity, scalable design.
"When you've seen what a properly planned home looks like versus one that was figured out after the fact, you never want to figure it out after the fact again."
When should I bring in a network designer during a new home build?
As early as possible, ideally at the framing stage before insulation and drywall. The earlier we are involved, the less constrained we are and the cleaner the final result. Retrofitting a finished home costs significantly more than planning it right during construction.
Does NeuroDesk work with custom home builders in Windsor, Essex County?
Yes. We coordinate directly with builders and their trades throughout Windsor, Essex County, and the surrounding area. We provide them with exactly what they need to do the work right the first time.
Can I get smart home automation pre-wired in a new build?
This is the ideal scenario. Pre-wiring for smart home automation during construction is significantly cheaper and cleaner than retrofitting it into a finished home. We plan all audio, network, and smart home runs at the framing stage.
Can you design and install the structured wiring panel in a new home?
Yes. We design and install the central distribution point for all low-voltage cabling in the home, ensuring every run terminates correctly and the panel is organized for easy future access.